Cable Installation - Dantherm HCC 2 ALU Manual De Servicio

Cable installation

Connecting to LAN
MODBUS
Antenna
22
Pull the cable through the sheet metal plate next to the 230V AC input. This can either be on
the right or the left. See more at page 14
Press the cable in between the sheet metal and the EPS part.
Connect the unit to LAN using a standard Ethernet cable, fitted with RJ45 plug.
If using non pre-fabricated cable, please first run the cable through the house as needed and
mount the RJ45 plug using the standard Ethernet wire crossing terminology, as specified in
T568B. These mounting instructions can be found in the internet fx. on Wikipedia.
The unit will be accessible for the smartphone app (IOS and Android), if your device is con-
nected to the same network via WIFI.
IP adress Description
allocation status
Dynamic IP If the unit is connected to a router with built-in DHCP server it will
fetch the IP address itself from the router when the unit starts up.
Static IP Using PC Tool it is possible to allocate a static IP address to the unit,
which is necessary for example in order to perform checks on HCC
2 via smartphone app when outside the LAN's range. This will also
require setup of the home's WAN address as well as allocating a port
on the router.
The MODBUS RTU connection can be connected to the hardware accessory controller (HAC or
HCP 10).
External antenna can be connected here, to gain higher coverage area.
Installation : Connecting additional equipment
Fig. 24