Silver King KutLett SKK2 Instrucciones De Operación página 4

SKK2 KUTLETT ASSEMBLY DIRECTIONS
TO DISASSEMBLE:
REFER TO THE ACCOMPANYING EXPLODED DIAGRAM TO IDENTIFY PARTS AND TO HELP
IN DISASSEMBLY. BLACK DOTS ON THE PLASTIC PARTS INDICATE THE FRONT SIDE.
1. SLIDE OFF THE BLADE HOLDERS AND CAREFULLY REMOVE AND SET ASIDE BOTH
SETS OF KNIFE ASSEMBLIES (GOLD AND SILVER).
2. DISCONNECT THE DOWN LINK ASSEMBLIES FROM THE HANDLE LEVER ASSEMBLY
BY APPLYING A SLIGHT INWARD PRESSURE WHERE THEY ATTACH UNTIL THEY CLEAR
THE STUD ON THE HANDLE LEVER ASSEMBLY.
3. RELEASE THE TENSION ON BOTH SPRINGS BY DISENGAGING THE TRIANGULAR ENDS
OF THE SPRINGS FROM THE HANDLE LEVER ASSEMBLY.
CAUTION: THESE SPRINGS ARE UNDER TENSION AND MUST BE RELEASED SLOWLY
TO GUARD AGAINST INJURY. THE HANDLE LEVER ASSEMBLY WILL FALL DOWNWARD
WHEN SPRING TENSION IS RELEASED. KEEP HANDS AWAY FROM THE CUTTING
AREA.
4. PULL BOTH .P. PINS UPWARD UNTIL THEY ARE CLEAR OF THE HOLE IN THE PIVOT
PINS AND HANG FREELY.
5. AT THIS POINT SLIDE THE PUSHER PLATE UP ON THE UPRIGHT HANDLE AND LAY THE
KUTLETT ON ITS BACK.
6. REMOVE PIVOT PINS.
7. REMOVE HANDLE LEVER ASSEMBLY AND BOTH .P. PIN BRACKETS.
8. RETURN THE UNIT TO ITS UPRIGHT POSITION.
9. REMOVE BOTH SPRINGS BY PULLING THEM OUT OF THE HOLES IN THE BLADE
HOLDER FRAME.
10. REMOVE THE UPRIGHT HANDLE BY PULLING IT STRAIGHT UP. THIS WILL FREE THE PUSHER PLATE,
DOWN LINK ASSEMBLIES, BLADE HOLDER FRAME AND LEGS.
11. THE BLADE HOLDER FRAME CAN NOW BE REMOVED FROM THE LEGS BY PULLING
THEM APART.
12. THE LEG GLIDES CAN BE REMOVED BY UNSCREWING THEM FROM THE LEGS.
3
Searchable, web-optimized PDF created using a watermarked evaluation copy of CVISION Maestro