Collision Sentry Corner Pro Instrucciones De Instalacion Y Uso

Instructions for installing and using
Collision Sentry
collision warning device
1.
Remove from package
If there are any visible signs of product
damage, contact Sentry or your
authorized product distributor
immediately.
3.
Mounting
2 - 2.75 m
The ideal placement for the unit is at a
height between 7' and 9' (2-2.75 m).
Install with the mounting tabs at the top.
6.
Installation on non-metallic
corners
Use the integrated mounting tabs to
install the unit directly to non-metallic
surfaces.
Corner Pro
®
2.
Activate the product
To activate the Collision Sentry Corner
Pro, pull out the plastic battery tab
located inside the unit. Remove the door
on the front of the unit, pull the tab and
replace the door. This activates the three
(3) "D" cell batteries that are included
with each unit. The LED lights will begin
blinking as the device becomes oriented
to the environment. During this warm-up
period, the blue low battery indicator
also flashes.
Note* - Always activate the unit prior to installation. Pull the tab, close the door and
the install the unit to the upright.
4.
Installation on racking or metal
corner
7 - 9'
Use the integrated magnets on the back
to "snap" the unit to a metallic corner or
rack.
7.
Collision Sentry Corner Pro is now ready for use
The product needs about 20 seconds to
acclimate to the new environment and
"learn" its new surroundings. During
this warm-up, the warning lights will
flash. The lights will go solid red for four
seconds at the end of the warm-up
period. This indicates the product is
ready to use.
5.
Tether to rack or corner
The included nylon tether provides extra
security when mounting the unit using
the magnets. Using the tether is optional
but recommended.
Form 102019 – 5M – 10/2019