Normal Operation; Low-Battery - Collision Sentry Corner Pro Instrucciones De Instalacion Y Uso

8.
Alarm adjustments
Collision Sentry Corner Pro ships with the audio alarm
activated and set to the highest volume. This alarm can be
adjusted using the switches found inside the unit and located
below the battery compartment. (See illustration). There are
two switches used for adjusting the volume – a high/low
switch and an off/on switch.
1. Remove the door on the front of the unit.
2. Alarm switches are located below the battery compartment.
3. Adjust the switches to the desired setting.
4. Reinstall battery door.
5. Unit is now ready for use.

Normal Operation

When motion is detected on both sides of the corner, the LED
lights flash and the alarm sounds. The flashing and beeping
continue until 1.6 seconds after motion has stopped. Both
alarms – audio and visual – can be individually engaged or
disengaged. (See instruction 8)

Low-Battery

1. Depending on usage, in regard to the battery life of the three
(3) "D" cell batteries, all estimates point to a minimum of
twelve (12) months.
2. When battery voltage drops below a specified threshold, a
blue light on the front of the Collision Sentry flashes and
beeps. Install new batteries.
3. Note – when the low battery light activates, the Collision
Sentry continues to function for a short period of time. The
life cycle of the batteries depends on usage.
4. TO ENSURE FULL PROTECTION, CHANGE BATTERIES AS
SOON AS THE LOW-BATTERY SIGNAL FLASHES AND BEEPS.
Changing Batteries
The Collision Sentry Corner Pro operates on three (3) standard
"D" cell batteries that are easily replaceable.
1. Remove door on front of Collision Sentry Corner Pro unit.
2. Remove old batteries.
3. Insert new batteries in same orientation as the originals.
4. Reinstall door.
5. The unit is now ready to use.
For further details and trouble-shooting
please refer to online documentation.
Go to: www.sentrypro.com
Collision Sentry Corner Pro Limitation
®
1. Collision Sentry Corner Pro is a motion sensor device that
works when both sensors detect movement at the same
time. Any factor that limits the sensors' ability to see or
detect a change in infrared light, limits or prevents the
product from working properly. These factors include:
a. Objects blocking the sensors' field of vision.
b. If vehicles or pedestrians do not exhibit any infrared
signature (highly unlikely, but possible) the sensors may
have trouble detecting motion. This will limit product
effectiveness.
c. Ambient temperature in the facility can affect the
sensitivity of the sensor.
d. Objects moving very slowly may not be detected.
2. The presence of certain (strong) electrical fields in the
environment could cause the Collision Sentry Corner Pro to
momentarily false alarm. In the (rare) event that interference
occurs, the user can try to mitigate the interference by
re-orienting or relocating the Collision Sentry Corner Pro or
by increasing the separation between the Collision Sentry
Corner Pro and the source of the interference.
3. Collision Sentry Corner Pro is designed for INDOOR USE only.
4. Collision Sentry Corner Pro is a collision warning system
designed to supplement safety procedures already in place.
Its use does not replace or eliminate the need for forklift
operators and pedestrians to use extreme caution when
maneuvering through the facility.
5. Proper training is vitally important when deploying Collision
Sentry Corner Pro. A thorough understanding of how the
product works, what the signals indicate, the features and
limitations is needed to maximize the product's effectiveness.
We highly recommend testing the Collision Sentry Corner Pro
on-site to determine the fitness of the product for use in your
facility.