Inserting Bits (Hex Bit Holders); Inserting Drill Bit (Keyless Chuck) - Hilti SFE 2-A12 Manual De Instrucciones Original

5.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the adapter
Other adapters can be fitted additionally onto the right-angle adapter.
1. Insert the adapter into the chuck.
➥ The adapter snaps into engagement.
2. Check correct installation.
5.5 Removing the adapter
1. Pull the locking sleeve and hold it in this position.
2. Remove the adapter.

5.6 Inserting bits (hex bit holders)

The hex bit holders of the eccentric adapter and the right-angle adapter
hold the bit magnetically.
1. Pull the locking sleeve and hold it in this position.
2. Insert the bit.
3. Release the locking sleeve.

5.7 Inserting drill bit (keyless chuck)

1. Open the keyless chuck.
2. Insert the drill bit.
3. Close the keyless chuck.
6 Operation
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Selecting the gear
▶ Operate the gear selector switch.
*2236949*
Printed: 07.08.2019 | Doc-Nr: PUB / 5507951 / 000 / 00
4
3
2236949 English 11