Installing The Faucet - InSinkErator 2200 Serie El Manual Del Propietario

2

INSTALLING THE FAUCET

A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Make sure to use rubber O-ring
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
D
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
6
to ensure proper seal.
I I
Unpack dispenser components.
I I
On a firm, flat surface, carefully
straighten the copper tubing.
I I
Ensure that the black O-ring is
properly seated in the base of the
dispenser head (the groove on the
underside of the dispenser).
I I
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
I I
From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
I I
Place hex nut onto the threaded stud.
Ensure faucet head is at desired angle.
I I
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.