Remote Control; Remote Control Operations; How To Insert Batteries Into Remote Control - Kenmore 580.75062 Manual Del Propietário

REMOTE CONTROL
Note: The Remote Control wilI not operate properly if
strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote
Control and the Air Conditioner.
Every time you push button, you wilI hear beep sound
from the Air Conditioner.
1 6 3
4 2 5
5
FIG. 16
REMOTE CONTROL OPERATIONS
1. POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cooi mode, High
fan speed, Temperature setting at 72°F.
2. TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of 60°F to
86°F by increments of 1 °F.
3. MODE
- Every time you push this button, it will shift among
COOL, ENERGY SAVER and FAN.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan wilI turn on and
the unit will check the room air to determine if cooling
is needed.
4. FAN SPEED
• Every time you push this button, it advances the setting
as follows: {High(F3) -+ Low(F1) -, Med(F2) -, High(F3)}
-12-
5. TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• With unit running, use Timer to set number of hours
until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min, and
2°F after another 30 min.
• Every time you push Timer button, it advances the
Timer setting as follows: 1 Hour -* 2 Hours -* etc. -*
12 Hours maximum.
- START TIME
• With unit not running, use timer to set number of
hours before unit starts.
• Every time you push Timer button, it advances the
Timer setting as follows: 1 Hour -* 2 Hours -* etc. -*
12 Hours maximum.
HOW TO INSERT BATTERIES
INTO REMOTE CONTROL
1. Remove the cover from the back of the remote controller.
2. Insert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
17
• Do not use rechargeable batteries. Such batteries
differ from standard dry cells in shape, dimensions, and
performance.
• Remove the batteries from the remote controller if the air
conditioner is not going to be used for an extended
length of time.
• In order to prevent discharge, remove the batteries from
the remote control if the air conditioner is not going to be
used for an extended period of time. Keep the remote
control away from extremely hot or humid places. To
maintain optimal operation of the remote control, the
remote sensor should not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the
mountabie holder.
FIG. 18