Removal From Window - Kenmore 580.75062 Manual Del Propietário

D IF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a
2"(51mm) wide wood strip to the inner window sill
across the full width of the sill. The wood strip should
be thick enough to raise the height of the window sill
so that the unit can be installed without interference
from the the storm window frame. See FIG. 10.
Top of wood strip should be approximately
3/4"(19mm) higher than the storm window frame to
help condensation to drain properly to the outside.
• Install a second wood strip (approximately
6"(152mm) long by 11/2"(38mm) wide and same
thickness as first strip) in the center of the outer sill
flush against the back of the inner sill. (FIG. 10)
WOOD STRIPMOUNTED
ON TOPO_
SILL _/_V_/O/_/SS/T/_
INDO0_
1 1/2" rnin. 3/4"(19mm)
(38mm) CLEARANCE
o- ,
STORM
_ WINDOW
/J_/_ FRAME
//}/ OUTER
_// SILL
_// OUTDOOR
When storm window
frame is located on outer sill FIG. 10
D INSTALLATION FOR OTHER TYPE
WINDOWS.
• Dimensions and geometry of windows are different
according to manufacturers. Check your window
and refer to FIG.11 to install the support bracket
firmly.
(a) When window frame is located on inner sill,
• Install a wood strip (window width long and
window frame height high) on the inner sill.
SASH WINDOW _-_
WINDOWFRAME_.
WOOD STRIP
_///////////////_ O UTDOOR
(b) When the window frame is higher than
19/32"(16mm)
• Install a wood strip (about 4"(102mm) long) on the
outdoor sill to raise support bracket,
WINDOWFRAME_ FWOODSTRtP
19/32"(1_
'NNFLR_
_///////////////_ O UTDOOR
BILL
FIG. 11
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• Unscrew the side screws that you installed in Step 5.6.
• Close the curtain frame and remove foam seal and L
bracket from the windows.
• Keep a firm grip on the air conditioner raise the sash.
• Lift the air conditioner from the window and remove the
foam strip from between the windows.
• Remove the support bracket from window frame.
NOTE: When cooling season is over, unit is removed
from window for cleaning and storage. There may still be
some condensation water in the basepan. Remove the
unit carefully to avoid water being spilled out on floor,
always store unit fiat on its base. Do not stand on end. Be
sure to remove support bracket, L bracket, and foam seal
from window and save. Window will not close if support
bracket remains installed.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-