Brightness Control; Setting; Autonomous; Afnor Nfs 87500 Code Receiver - Gorgy Timing LEDI 1S Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The brightness is adjusted by pressing on the "+" and "-" button.
The button can be reached through the holes in the front of the unit, using a small screwdriver

4.1. AUTONOMOUS

The time is set by using the "+","-" and "PROG" buttons on the front of the unit.
Each time the "PROG" button is used, a different part of the display begins to flash. This is
then modified by using the "+" and "-" buttons.
The setting cycle is as follows:
Hour, minute, second display: adjustment of hours
Hour, minute, second display: adjustment of minutes
Hour, minute, second display: synchronisation
Hour, minute, second display: time base

4.2. AFNOR NFS 87500 CODE RECEIVER

The code is getting at right time when the code is connected on the «CODE» connector.

4.3. SMPTE / EBU RECEIVER CODE

Clock used to read the time code SMPTE or EBU delivered at standard speed.
Connect the code to the input terminal
Automatic adaptation to SMPTE or EBU format
Automatic selection at the rate of 24.25 or 30 images a second
Maximum error tolerance for the rate of code received : +/- 10%
Display freezes on last frame received if the signal emitter stops functioning
MDE-LEDI1S-2S-1066V1.0
3.

BRIGHTNESS CONTROL

4.

SETTING

21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ledi 1s ntpLedi 2s

Tabla de contenido