Claus C20 Manual Del Usuario página 8

SAFETY INSTRUCTIONS CAUTION:
CAREFULLY READ THE FOLLOWING SAFETY INSTRUCTIONS, BEFORE ASSEMBLING THIS EQUIPMENT, IN ORDER TO PREVENT ELECTRICAL SHOCKS, INJURY AND
OTHER DANGERS.
PLEASE, KEEP THIS MANUAL WITH YOU.
The C20 motor is conceived for the opening and closing of CLAUS windows.
Do not forget that during mounting and unsetting operations the window can move, bangings may cause knacks or breaking-off of the window frame.
• Installation must be carried out by qualified and expert technical personnel.
• After the packaging removal, make sure that the equipment has not been damaged.
• Plastic bags, polystyrene, nails, etc. must be kept out of reach of the children, as they are a potential source of danger.
• Before connecting the motor, verify that your supplied voltage corresponds to the equipment voltage, indicated on the technical data label, which is applied
on it.
• This equipment must only be used for the purpose for which it has been built.
The manufacturer cannot be considered liable against any damage or problem, arising from the misuse.
• Installation must be carried out in accordance with the manufacturer's instructions. The non-observance of these instructions may compromise the safety.
• Caution: danger of squeezing or pulling. While closing the window, the actuator pulls the ledges with a force more than 200N, and this pressure is quite
enough to press your fingers if no attention is paid for.
• Caution: upon the window frame, the wind load may rest on the window, and in particular situations, it may also be overloaded by the weight of the snow.
• Caution: each window frame can support just one shutter.
• Electrical power supply, must respect the regulations in force.
• To grand an effective separation between the net and the equipment, upstream the appliance, an approved bipolar differential temporary switch (push-
button) must always be installed. Upstream the command line, a general feed omnipolar differential switch, with an opening distance of at least 3 mm from
the contacts must be installed.
• Do not wash the motor with solvents or water jets. Do not plunge the appliance into the water.
• Caution: in case of fault, or bad-working, turn the equipment off, disconnect it from the power supply and call the customer service.
• Repairs must be carried out only by qualified personnel from a service organization, which is authorized by the manufacturer.
• Do always request only original spare parts. The non-observance of the above mentioned warnings, may compromise the safety and it will cancel the benefits
related to the guarantee of the equipment.
• In case of any problem or doubt, contact your reliable dealer.
8