Geared Motor Installation; Rack Installation - entrematic Ditec CROSS30 Manual De Instalación Y Mantenimiento

X+20
65*
OPENING
Ø80
65* 116 230
min
400
90

3.3 Geared motor installation

- Open the gear motor removable cover. Loosen the three
screws [A]
and remove the case.
- Remove the nuts used to fasten the anchoring brackets.
- Position the gearmotor onto the base plate.
- Gearmotor adjustments
Horizontally, by having it slide along the gear motor base
slot (approx. 20 mm).
Vertically, by means of the 4 level screws [B] and by insert-
ing the provided shims [C].
A
A TCEI-M8x16
OPENING
Ø80 Ø12
116 230 54
400
Ø12
X+20
54 65*
TC-M8x20
A TCEI-M8x16
65*
min
90
B
C

3.4 Rack installation

- Release the gearmotor and set the gate in the open po-
sition. Place the rack on pinion [14] and move the gate
manually to secure the rack along its full length.
- Once the rack has been secured, vertically adjust the
geared motor so as to have a gap of 2 to 3 mm between
the pinion and the rack with screws [B].
- Firmly secure the gearmotor with the nuts [D].
- Slightly lubricate the rack and pinion after assembly.
Manually check that the gate slides evenly and without
friction.
11
B
C
A
A
B
CROSS30 - IP1777