Installation; Test Running; Service; Filterchange - Dustcontrol S 11000 Manual Original

Installation

Assemble the dust separator. Mount it on the stand or the
wall bracket.

Test running

Check that the vacuum producer is correctly installed and
in- and outlet is connected to the dust system. Th e tubing
between the dust separator and the vacuum producer
must be free from particles. Objects in the vacuum pro-
ducer can cause failure.
Check discharge arrangement. No leakage is accepted.

Service

If the system does not give full suction after fi lter clea-
ning, it is recommended to exchange the fi ne fi lter. Use
only original fi lter.
Th e condition of the fi lter can be checked by meassuring
Filter change
Th e fi ne fi lter should be changed at least once per year.
Only original fi lter is allowed. Use breathing protection
during the fi lter change. Do not expose unprotected
persons to harmful dust.
- Turn off and lock the disconnect.
- Use breathing protection.
- Disconnect the top of the machine.
- Lift off the top.
- Lift out the fi ne fi lter and seal it in a plastic sack.
- Lift in the new fi lter and connect the top
S 11000, S 11000X:
Connect the tubing to the inlet and outlet. Connect the
fi lter cleaing to compressed air 4 l/s, 4 bars and control
voltage 24 V AC, 1 A, which should be taken from the
systems control.
Start the system. When the fi lter is cleaned a number of
clear air pulses should be heared by ca 5 sek interval.
the pressure drop over the dust extractor. Compare with
the curve in "technical data". If the pressure drop is hig-
her, the fi lter should be exchanged.
If the extracted dust is collected in a plastic bag, the
bag should be changed when the dust level is
5 cm under the rubber foot valve at the bottom of the
cyclone. Th e plastic sack must be sealed when removed
from the cyclone.
If the dust is collected in a container, it should be
changed or emptied before it is completely full.
S 11000, S 11000X - 17 Part No 9057