Canopy Installation - Kinderkraft INDY Manual De Usuario

EN
I BUGGY COMPONENTS (FIG. 1)
A. Frame with mounted seat, safety harness and canopy
B. Front wheels x2
C. Rear wheels x2
D. Safety bar
E. Footmuff
F. Rain cover
II UNFOLDING BUGGY FRAME
Place the frame on a flat surface with its handle up (FIG. 2). In order to unfold the
frame you must first move the slider, press the lock button (both elements are
located on the parent handle) (FIG. 3A) and lift the frame up until you hear the locking
sound (FIG. 3B). Note! To facilitate the unfolding of the frame, push the parent
handle to the stroller frame in such a way that all the elements fit tight. The lock
mechanism is unlocked correctly.A properly unfolded frame is shown in FIG. 4.
III WHEEL ASSEMBLY/DISASSEMBLY
Insert the rear wheels in the rear axle until you hear the locking sound (FIG. 5).
To remove the rear wheel, press the button on the rear axle (FIG. 6A) while pulling
the wheel out of the slot (FIG. 6B).
Insert the front wheels in the slots at the front of the frame until you hear the locking
sound (FIG. 7A).
To remove the front wheels, push the button located on the frame under each wheel
(FIG. 7B).
NOTE! Before using the buggy, make sure that all the wheels are
properly installed.
IV CANOPY INSTALLATION
A brand new buggy comes with a partially mounted canopy. However, also fasten the
Velcro fastener underneath the backrest and the press studs on the sides of the shell
(FIG. 8A and 8B). A correctly mounted canopy is shown in FIG. 9.
V ASSEMBLY/DISASSEMBLY OF THE SAFETY BAR, FOOTMUFF AND RAIN COVER
The safety bar must be inserted in appropriate slots on both sides of the frame, as
shown in FIG. 10.
To remove the bar, press the buttons on both sides and remove the bar (FIG. 11).
21