Installation Sequence - Windhager BIOWIN 2 TOUCH Manual De Instrucciones

2.

Installation sequence

2.2 Removing the crate
– Remove both fastening straps – Fig. 4.
– Remove wooden crate. Caution: The cladding door is loose inside the crate!
– Remove the side panel from the hopper by unscrewing both cross screws at the top (Fig. 5) and then lifting off the
side panel – Fig. 6.
– Remove the pedestal by taking out 3 screws each on both sides (Fig. 7) and then lifting off the pedestal – Fig. 8.
CAUTION
– Lift the container off the pallet and rotate it by 180° – Fig. 9.
Fig. 4 Remove the fastening straps
Fig. 6 Remove side panel
Fig. 8 Remove pedestal
The pedestal must be dismantled! Otherwise, it is not possible to install the tank cor-
rectly on the boiler; leaks or inleaked air would result.
Fig. 5 Remove 1 Phillips screw in each case
Fig. 7 Remove 6 screws
Fig. 9 Rotate hopper in correct position
16
EN