5. INSTALLATION INSTRUCTIONS
5.1. Precautions
Be sure to be in conformity with the local, national and international laws and regulations.
Read "Precautions" carefully before installation.
The following precautions include important safety items. Observe them and never forget.
Keep this manual in a handy place for future reference.
!
Failure to observe a warning may result in death.
WARNING
!
Failure to observe a caution may result in injury or damage to the equipment.
CAUTION
After completing the installation, make sure that the unit operates properly during the start-up operation. Please instruct the
customer on how to operate the unit and keep it maintained. Also, inform customers that they should store this manual for
future reference.
5.2. Installation information
To install properly, please read this "installation manual" at first.
The air conditioner must be installed by qualified persons.
When installing the indoor unit or its tubing, please follow this manual as strictly as possible.
If the air conditioner is installed on a metal part of the building, it must be electrically insulated according to the relevant
standards to electrical appliances.
When all the installation work is finished, please turn on the power only after a thorough check.
Regret for no further announcement if there is any change of this manual caused by product improvement.
5.3. Installation order
Select the location;
Install the indoor unit;
Install the outdoor unit;
Install the connecting pipe;
Connect the drain pipe;
Wiring;
Test operation
5.4. Indoor unit installation
5.4.1. Installation place
The indoor unit should be installed in a location that meets the following requirements:
There is enough room for installation and maintenance. (Refer to the 2 figures below)
The outlet and the inlet are not impeded, and the influence of external air is the least.
The air flow can reach throughout the room.
The connecting pipe and drainpipe could be extracted out easily.
There is no direct radiation from heaters.
Keep indoor unit, outdoor unit, power supply wiring and transmission wiring at least 1 meter away from
televisions and radios. This is to prevent image interference and noise in those electrical appliances.
!
CAUTION
(Noise may be generated depending on the conditions under which the electric wave is generated, even if
1 meter is kept.)
5.4.2. Minimum installation space
≤ 100 mm
≤ 1000 mm
30