Set-Up; Preparing For Set-Up; Set-Up Instructions - Allmand PORT-A-LITE POL 1000W2 Manual Del Operario

2
Ref
A Power Cord
B Lamp Cable
C Lamp Fixture
D Lamp Fixture Yoke
E Lamp Fixture Cord
F Handle Nut (partially hidden)
G 3/4" Flat Washer
H Plastic Washer
I Base Assembly
J Mast Socket Knob
K Base Assembly Stud
L Outer Mast
M Inner Mast
N Latch Spring Pin
O Hook and Loop Cable Tie
P Power Switch

Set-Up

Preparing For Set-Up

Allmand Port-A-Lite® PAL 1000W2 / PAL 1250W2 portable
work lights are shipped in three cartons, and require assembly
before use. Upon receiving the Port-A-Lite®, remove each piece
Description
from the shipping cartons and inspect the parts for damage.
Contact your dealer or Allmand if parts were damaged during
shipping.

Set-Up Instructions

1. Loosen the mast socket knob (A, Figure 3).
2. Insert the outer mast (B, Figure 3) in the socket, and tighten
the knob.
3. Make sure the inner mast (C, Figure 3) is completely
lowered, and that the latch spring pin (D) is engaged in the
hole in the inner mast.
4. Remove the handle nut (E, Figure 3) and flat washer (F)
from the stud (H) on the base assembly, leaving the plastic
washer (G) in place.
5. Place the center hole of the lamp fixture yoke (I, Figure 3)
onto the stud on the base assembly, and secure with the
handle nut and flat washer removed in Step 4.
6. Coil the power cord (J, Figure 3) and lamp cable (K), and
secure with the hook and loop cable tie (L).
3
5