Allmand PORT-A-LITE POL 1000W2 Manual Del Operario página 7

WARNING
Rollover / Tipover Hazard.
Positioning the portable work light on soft or unstable ground
could cause work light rollover resulting in death or serious
injury. Always position the work light on a firm, level and stable
surface.
Wetness & Wind
The portable work light must be placed on a dry surface away
from areas that might become wet.
WARNING
Shock Hazard.
Positioning a portable work light on a wet surface or in water
will result in death or serious injury. Always position the work
light on a dry surface away from areas where water may flow
or accumulate.
Do not set up the work light in an area where winds exceed 10
mph (16 km/h).
WARNING
Unsafe Operation Hazard.
Operating the portable work light with the mast fully elevated
in winds exceeding 10 mph (16 km/h) can cause work light
tip over resulting in death or serious injury. Always fully lower
the mast when winds are expected to exceed 10 mph (16
km/h).
Operating The Port-A-Lite
To Operate The Port-A-Lite
1. Install and connect the lamp fixture.
1. Remove the handle nut and flat washer from the stud
on the base assembly, and remove the lamp fixture
from the stud. Place the center hole of the lamp fixture
yoke onto the stud on the inner mast and secure with
the flat washer and handle nut.
Note: The Port-A-Lite® PAL 1000W2 / PAL 1250W2 portable
work light may be used with the lamp fixture mounted to the
base or on the mast. Do not attempt to use the lamp fixture as
a hand held light source.
WARNING
Burn Hazard.
Handling light fixtures when they are hot could result in death
or serious injury. Always keep clear of light fixtures when
illuminated or hot.
2. Loosen the hook and loop cable tie securing the cords.
Connect the lamp cable to the lamp.
2. Position the lamp fixture. The lamp fixture may be
rotated left / right, and up / down.
3. If the lamp fixture is attached to the mast, raise the mast
to the desired height.
1. Pull the latch spring pin and rotate it 90°.
2. Raise the inner mast to the desired height. There are
four holes in the inner mast that may be used.
3. Rotate the latch spring pin 90° and engage one of the
four holes in the inner mast. Be sure the latch spring
pin is fully seated in the hole.
4. Connect the power cord and turn on the work light.
7