Chauvet Professional EPIX Guía De Referencia Rápida página 4

Idiomas disponibles

Connecting ÉPIX Flex Products

The ÉPIX Flex Drive is the power supply for the ÉPIX Flex series of products. Each product must be daisy-chained

together in series. This power supply is capable of powering up to 1,920 LEDs (960 from each port).

Connect the ÉPIX Flex Boost

directly to the previous ÉPIX Flex 20.

The ÉPIX Flex Drive can support 2 ÉPIX Flex 20 products with each port by itself, for a total of 4 ÉPIX Flex 20

products.

Connect an ÉPIX Flex Boost after the second ÉPIX Flex 20 product on each port to enable the ÉPIX Flex

Drive to support an additional 2 ÉPIX Flex 20 products with each port. This increases the total to 8 ÉPIX Flex

20 products (4 per port).

The recommended connection order from each port of the ÉPIX Flex Drive is as follows:

1. ÉPIX Flex Drive port

2. ÉPIX Flex 20

3. ÉPIX Flex 20

4. ÉPIX Flex Boost

5. ÉPIX Flex 20

6. ÉPIX Flex 20 (end)

•

Make sure the length of cables between each ÉPIX Flex Drive port and the first ÉPIX Flex 20 does not

exceed 75 ft (22.9 m).

•

Make sure the length of cables between each ÉPIX Flex 20 does not exceed 10 ft (3 m).

•

Make sure the ÉPIX Flex Boost is plugged directly into the previous ÉPIX Flex 20.

•

Make sure the length of cables between the ÉPIX Flex Boost and the next ÉPIX Flex 20 does not exceed

30 ft (9.1 m).

Use ONLY CHAUVET Professional cables with the ÉPIX Flex Drive. For our line of cables compatible

with the ÉPIX Flex Drive, go to https://www.chauvetprofessional.com/accessories.

QUICK REFERENCE GUIDE

Length of cables between ÉPIX Flex Boost and the

next ÉPIX Flex 20 must not exceed 30 ft (9.1 m).

Length of cables between ÉPIX Flex Drive and

1st ÉPIX Flex 20 must not exceed 75 ft (22.9 m).

Length of cables between ÉPIX Flex 20

products must not exceed 10 ft (3 m).

ÉPIX Flex Drive QRG Rev. 2

Tabla de Contenido