Routing Other Size Mortise And Tenons - General Tools & Instruments GENERAL EZ 870 Manual Del Usuario

ROUTING OTHER SIZE MORTISE AND TENONS

The E•Z Pro Mortise and Router Guide Bushing Tenon Jig Kit includes the guide sleeve with
Locking Nut [R2, R1], a 1-1/8" Router Guide Bushing for 1/4" joints [R3], a 1/4" Upcut Spiral
Router Bit and a Centering Pin [R4]. These parts will permit you to make 1/4" mortises and tenons
suitable for 3/4" thick board (Fig 26). The kit also includes the Guide Bushing you will need to make
mortises and tenons of 1/2" [R7] or 3/8" [R6] (Page 4), however, you will need to make a separate
purchase of the corresponding Upcut Spiral Bits. Please see sizing chart on Page 10.
• To make a 3/8" tenon, you'll need a 3/8" Upcut Spiral Bit and the 7/8" Guide Bushing [R6].
• To make the matching 3/8" mortise, change to the 1-1/8" Guide Sleeve [R-3]. (Fig. 27)
• To make a 1/2" tenon, you'll need a 1/2" Upcut Spiral Bit and the 5/8" Guide Bushing [R7].
• To make the matching 1/2" mortise, change to the 1-1/8" Guide Sleeve [R-3]. (Fig. 28)
NOTE: Guide Bushings can be changed without removing router bit.
Fig. 26
1/4" JOINT
(shown on
1" stock)
Fig. 27
3/8" JOINT
(shown on
1-1/4" stock)
Fig. 28
1/2" JOINT
(shown on
2" stock)
MORTISE
MORTISE
MORTISE
TENON
TENON
TENON
13