Great White GW9500 Owner’s Manual página 4

Step 6: Assemble cleaner (Figure 6)
Insert swivel assembly into cleaner; twist 1/4 turn.
Swivel
Assembly
Figure 6
Step 7: Measure hose length needed (Figure 7)
Before connecting the hose, lay it out from the vacuum
connection you are using (whether skimmer or dedicated
wall fitting) to the furthest point of the pool. The hose
should be at least 4' longer than this. More than 4'
longer is OK. Do not cut the hose. Fill the hose with
water and keep the ends accessible.
Figure 7
Step 8: Install Regulator
Install the regulator and reducer cone in the skimmer.
Refer to illustrations A and B on the following page.
Attach the end of the hose to the regulator (Figure 8), or
to the vacuum port (Figure 9) depending upon your pool.
Skimmer
Regulator
Adapter Cone
To Pump
Figure 8: Regulator
installed with hose
connection.
INSTALLATION
Skimmer
Cap
Regulator
Adapter Cone
To Pump
Figure 9: Regulator
installed with cap.
Step 9: Check Flow
Close the main drain and insert one end of the hose into
the vacuum source (skimmer or vacuum port: see
below). Insert the flow gauge into the other end of the
hose, Keep the hose and flow gauge underwater. Turn on
the pump.
With the pump running, adjust the regulator until the
indicator on the flow gauge is between minimum and
maximum flow.
Remove the flow gauge and attach the hose to the cleaner.
Figure 10
Step 10: Connect Hose to Cleaner
Connect the hose cuff of the 20' hose to the swivel
assembly in cleaner (correct end of hose is marked). Fill
the cleaner with water and let it sink to the bottom.
Verify hose connections as shown below, and that gate
valves are fully open in the suction line.
Figure 11
Figure 12
4
Disc Indicator
Hose Cuff
marked
"Connect
to Cleaner"
1875 0795