General Operation - Steamfast SF-540 Guia Del Usuario

GENERAL OPERATION

NOTE: Be sure that Water Tank has been filled and, if desired, the Fabric Brush or Crease Tool is
connected before following these steps.
1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power cord
into a convenient electrical outlet.
CAUTION: This unit uses a grounded electrical plug with three prongs. This plug will fit into a
wall outlet only one way. If the plug does not correctly fit in the outlet, contact a licensed electrician
to install a proper outlet. Do not attempt to alter plug or circumvent this safety feature in any way.
2. Set Lighted On/Off Switch to "ON" position, and verify that switch is illuminated.
3. After approximately 45 seconds of heating time, unit will begin producing a flow of steam from Steam
Nozzle.
NOTE: It is common for the unit to produce gurgling sounds and small amounts of water during
the first few minutes of steaming. This is due to water condensation inside cold Hose, and
should be reduced as the Hose heats up.
4. Once steam flow is steady and excess condensation has been removed from Hose, you may proceed
with your steaming tasks. Refer to Fabric Steaming section on Page 11 for more information about
steaming garments and other fabrics.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from yourself,
other people, pets and plants) when steaming.
5. When you are finished using the Deluxe Fabric Steamer, immediately set Lighted On/Off Switch to
"OFF" position and unplug power cord from electrical outlet. Refer to Storage & Care on Page 12 for
proper cleaning and storage procedures.
USING GARMENT CLIP
1. Make sure Garment Clip is properly connected to Telescopic Pole (refer to Page 8 for details).
2. Hang garment on unit, using either the Hanger or Hanger Hook.
3. Open one of the clasps and insert one side of the garment. Repeat for other clasp/side.
4. Slide Garment Clip down towards bottom of Telescopic Pole, until pants are pulled taut.
5. Proceed with steaming. Using the Crease Tool is recommended for creating crisp creases.
USING CREASE TOOL
1. Make sure Crease Tool is properly connected to Steam Nozzle (refer to Page 8 for details).
2. Hang garment on unit, using either the Hanger or Hanger Hook.
3. Press in on lever to open Crease Tool.
4. Insert edge of fabric between face of Steam Nozzle and Crease Tool. Release lever to close Crease
Tool.
5. While pulling on bottom of garment to stretch it taut (either by hand or using the Garment Clip),
slowly pull Steam Nozzle downward along edge of fabric.
NOTE: It is recommended to start at top of garment and pull Steam Nozzle downward.
6. Press in on lever again to open Crease Tool and release fabric. Repeat STEPS 3-6 as necessary.
10 | ENGLISH
Using Your
Deluxe Fabric Steamer