Zanussi ZWI 71000 WA Manual De Instrucciones página 17

Problem
The washing results are
not satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the display shows other alarm codes. Deactivate
and activate the appliance. If the problem
continues, contact the Service.
INSTALLATION
WARNING! Refer to Safety chapters.
CLEANING THE INLET HOSE AND THE VALVE
FILTER
Remove all transit bolts and packing
before you use the appliance. You are
advised to keep all transit devices so t
hat they can be refitted if the appliance
ever has to be transported again.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you
wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted button(s).
• After removing all the
packaging, carefully
lay the appliance on
it's back to remove
the polystyrene base
from the bottom.
• Remove the power
supply cable and the
draining hose from the
hose holders on the
rear of the appliance.
Possible solution
SERVICE
We recommend the use of original spare parts.
When contacting the Authorised Service Centre,
make sure that these data are available. You can
find the information on the rating plate: model
(Mod.), PNC (Prod.No.), Serial number (Ser.No.).
2
1
• Unscrew the three
bolts.
• Slide out the relevant
plastic spacers.
• Remove the
polystyrene block
fitted on the door seal.
Pull out all items from
the drum.
17