Installing The Quick Receivers; Installing The Tow Bar; Removing The Tow Bar - Burley D’Lite Instrucciones Del Propietario Y Manual De Seguridad

Installing the Quick Receivers

1. Position the Quick Receiver as shown (Figure 8).
2. Slide the Quick Receiver over the aluminum receiver mounts
until fully seated (Figure 8).
3. Insert the yellow sleeve into the Quick Receiver, with the
arrows pointed up, until it is flush with the Quick Receiver
(Figure 9).
4. Repeat on the opposite side.
Note: The underside of the Quick Receivers are marked with "R"
for Right and "L" for Left to denote which side they should be
used on.
Note: If you need to remove the Quick Receivers, insert a flat,
thin item (such as a key or flathead screwdriver) into the front
section of the forward slot on the underside of the receiver to
depress the retaining tab (Figure 10). After the retaining tab has
been depressed, slide the yellow insert sleeve out of the Quick
Receiver by pushing it from the rear.

Installing the Tow Bar

1. Slide the tow bar into the Quick Receiver until the primary
retaining pin engages with the tow bar (Figure 11).
- While inserting the tow bar, you should see the release
handle move outward and then return to its original position.
The tow bar is not secure until the release handle has
returned to its original position (Figure 12).
3. Pull on the tow bar to ensure that it is securely attached to
the Quick Receiver.
4. Depress the button on top of the secondary retaining pin and
insert it into the aligned holes through the Quick Receiver and
tow bar (Figure 13).

Removing the Tow Bar

1. Depress button and remove the secondary retaining pin.
2. Pull the Quick Receiver release handle and remove the tow
bar.
6
ENG
Figure 8
Figure 11
Figure 13
Figure 9
Figure 12
CHILD TRAILER
R
Figure 10
X