Specific Safety - Greenlee G1 Versi-Tugger Operación Manual

SPECIFIC SAFETY RULES AND SYMBOLS (cont'd)
An under-rated rope may break and whip
violently. Use a cable pulling rope with the
following characteristics:
• Maximum Rated Capacity:
at least 1500 lb (6.7 kN)
• Average Breaking Strength:
at least 6000 lb (26.7 kN)
• Rope Diameter Range: 1/4" to 1/2"
Failure to observe this warning could result in severe
injury or death.
• Check the condition of the entire rope before use.
A worn or damaged rope can break under tension
and whip violently.
• Do not maintain a stationary rope on a rotating
capstan. The wear generated may cause the rope
to break under tension and whip violently.
Failure to observe these warnings could result in
severe injury or death.
Attach the pulling rope to the cable with appropri-
ate types of connectors. Select connectors with
a maximum rated capacity of 1500 lb (6.7 kN). An
under-rated connector can break under tension.
Failure to observe this warning could result in severe
injury or death.
Keep hands away from the capstan.
Rope at the capstan can crush a hand.
Failure to observe this warning could
result in severe injury or death.
Do not wrap rope around hands,
arms, waist or other body parts.
Do not stand in spent coils or tailed
rope. Hold rope so that it may be
released quickly.
Failure to observe this warning could
result in severe injury or death.
Greenlee Tools, Inc.
Rope, cable, or a connecting device can break under
tension, causing the rope to whip violently.
• Do not allow any unnecessary personnel to remain
in the area during the pull.
• Do not allow any personnel to stand in line with the
pulling rope.
Failure to observe these warnings could result in
serious injury or death.
• Do not allow the rope to overlap on the capstan.
If the rope approaches the top of the angled part
of the capstan, relax the tailing force. If an overlap
does occur, shut off the puller immediately.
Failure to observe these warnings could result in
severe injury or death.
Only use the G1 Versi-Tugger with approved pistol
grip style 12V-20V cordless drills. Do not use the G1
Versi-Tugger with corded drills, right angle cordless
drills, D-handle or spade handle cordless drills,
impact drills, or pistol grip style cordless drills whose
voltage is rated higher than 20V.
DO NOT exceed maximum rated pull force of 1000
lb. Failure to observe this warning could result in
severe injury or death.
Use this tool for manufacturer's intended purpose
only. Do not use the cable puller as a hoist or winch.
• The cable puller cannot lower a load.
• The load may fall.
Failure to observe this warning could result in severe
injury or death.
6
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
G1 Versi-Tugger™