Chauvet NIMBUS Jr Guía De Referencia Rápida página 4

Nimbus™ Jr QRG
Setup
Operation
The top plate has two LED indicators – one red and one green. The red LED
indicates that the heater is on, and the green LED indicates the water is at its
optimal operating temperature. The heater will not turn on unless there is
enough water.
As the dry ice sublimates, the water will cool and the green LED indicator
will turn off. This is normal and the Nimbus™ Jr will continue to operate
until all the dry ice is used.
During operation, the top plate becomes very hot. DO NOT TOUCH!
The dry ice must be stored inside the internal basket for optimal performance.
Do not remove this basket as serious bodily injury may occur.
1. Place the machine on a level surface. Plug the power cord into the wall.
2. Raise the basket to its highest level with the operation lever.
3. Open the lid and fill with water until the red light comes on. The container
can hold up to 2.6 gallons (9.8 liters).
4. Using protective gear, load the basket with up to 5 lbs (2.3 kg) of dry ice.
The dry ice should be loaded at the last possible moment.
5. Close and latch the lid.
6. Grab the operating lever and slowly lower the handle to the middle notch
for low output or all the way down for high output.
7. When output slows or stops, raise and refill the basket.
Water temperature should be about 170° F (77° C) for optimal fog
output.
You may need to refill the Nimbus™ Jr with water from time to time.
Once refilled, wait for the red LED indicator to come on before repeating
Operation steps 4–7.
4
EN