Topcom SKYR@CER WBR 7201n Guía De Instalación Rápida página 14

Setup the Broadband Router
•
Use the following IP address:
1
2
3
•
L2TP Settings:
1
2
3
4
5
6
JClick OK to proceed.
Telstra Big Pond: not for Europe.
o
Now the quick setup wizard is finished.
J Click Apply to finish.
The router will reboot now. This will take about 60 seconds.
J Click OK when the reboot sequence is done.
8
IP address: Please enter the fixed IP address.
Subnet Mask: Enter the Subnet mask.
Default Gateway: Enter the Gateway IP address.
User ID: Enter the L2TP username.
Password: Enter the L2TP password.
L2TP Gateway: Enter the Gateway.
Connection ID: Enter the Connection ID when necessary.
MTU: Enter the MTU size. (If the size is not specified, please leave the
default value at 1492.)
Connection Type:
•
Continuous: The PPP-connection will always be active.
•
Connect on Demand: The PPP-connection will establish when a
computer is accessing the Internet. The PPP connection will
disconnect when there is no more Internet traffic during the Idle
Time (minutes), entered in the field below.
•
Manual: The PPP connection is established / disconnected
manually by clicking Connect / Disconnect.