Tabla De Contenido; Table Of Contents; Safety Information; Precautions - Defiant DF-5716-BK-A Guía Para El Uso Y Cuidado

Table of Contents

Table of Contents ......................................2
Safety Information ....................................2
Precautions ............................................2
Warranty ...................................................2
2-Year Warranty .....................................2
Specifications ...........................................3
Pre-Installation .........................................3
Planning Installation ..............................3

Safety Information

PRECAUTIONS

Please read and understand this entire manual before
attempting to assemble, install, or operate this motion
sensor.
This motion sensor requires 120-volts AC.
Some codes require installation by a qualified electrician.
This motion sensor must be properly grounded.
For proper operation, this motion sensor should be:
Installed outdoors to a wall or eaves
Installed 8 ft. (2.4 m) above the ground (If
the motion sensor is mounted higher than
recommended, aiming the sensor down will reduce
the coverage area.)
Do not leave the "ON-TIME" switch in the "TEST"
position. The frequent ON/OFF cycling of the light
fixture will reduce the life of the bulb

Warranty

2-YEAR WARRANTY

Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com.
Tools Required .......................................3
Hardware Included .................................4
Package Contents ..................................4
Installation ................................................5
Operation...................................................6
Care and Cleaning ....................................8
Troubleshooting ........................................9
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from standard PAR38 bulbs.
CAUTION: Keep the motion sensor at least 2 in. (50 mm)
away from halogen bulbs.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
NOTICE: Do not connect this motion sensor to a dimmer switch
or timer.
2