Installation Instructions - GE Monogram 30 Serie Instrucciones De Instalación

Installation
Instructions
WARNING:
performed by a qualified installer or gas supplier in
accordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work assumes
responsibility for the conversion.
WARNING:
from the factory, is set for use with its intended
gas. If you wish to use your rangetop with the
alternate gas, you must first replace the orifices
and convert the pressure regulator.
WARNING:
must be made before turning on the burner.
Failure to do so could result in serious injury. Be
sure pressure regulator has been converted as
described in Step 2.
TOOLS YOU NEEDED FOR CONVERSION
Crescent Wrench
Safety Glasses
1/2" Deepwell
Socket Wrench
1
ORIFICE HOLDER
The range orifice holder
is located behind the front
access panel at the bottom
of the range.
The rangetop orifice holder
is located inside the range
insulation cover.
Additional orifices may be present. Use only the orifices
specified in the instructions for your range or rangetop.
Convert Natural Gas to LP Gas Operation
Convert LP Gas to Natural Gas Operation
This conversion must be
The rangetop, as shipped
The following adjustments
1/4" and 7mm
Nutdrivers
Small Flat-Head Screwdriver
(2 to 2.4 mm or 3/32" tip size,
60 mm long)
Philips
Screwdriver
Small Pliers
Griddle
Orifice Orifice
Burner Orifices
2 CONVERT THE REGULATOR
Disconnect all electrical power at the main circuit
breaker or fuse box.
A. Remove the rear vent
trim (on ranges only) to
access the regulator.
The Rangetop regulator
is on the left bottom
corner.
B. Shut off the gas supply
by closing the manual shut-off valve in the unit or at the
wall.
C. Convert the pressure regulator:
• Unscrew the cap with plunger.
• Place your thumb against flat side of the plunger and
press down to snap the plunger out of the cap.
• Carefully look at the plunger to locate the NAT or LP
position.
• Turn the
plunger over
so that the
desired gas is
showing near
the bottom.
• Snap the
plunger back into the cap.
• Screw the cap back onto the regulator.
3 CHANGE BURNER ORIFICES
INSTALLATION TIP: First remove all
orifices and then start replacing them.
This will help to prevent the possibility
that some may not be replaced.
A. Remove the burner grates,
burner caps and burner heads.
B. Loosen the top burner
Grill
orifices using a 7 mm
nut driver. Use small
pliers to carefully lift out the orifices.
The main orifice is located low in
the center of the
burner, while the
simmer orifice is
located higher
beside the center
of the burner.
21
Range Regulator
Gasket
Cap
NAT
NAT
NAT. Position
Pressure Regulator
Burner Cap
Burner
Head
Spark
Igniter
Burner Base
Main
Orifice
LP
Plunger
LP
LP Position
Simmer
Orifice