Operation; Safety; Putting Into Operation; Switching On - Beurer TS 15 Instrucciones Para El Uso

4. Operation

4.1 Safety

CAUTION
• This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault. If the safety system has switched off the heated underblanket, the
temperature setting is not illuminated any more even when the heated underblanket is switched on.
• Please note that the heated underblanket is not operable any more due to safety reasons in this
case and has to be sent to the service address indicated.
• Do not connect the defective heated underblanket with another control of the same type. This would
trigger a permanent switch­off via the control's safety system.

4.2 Putting into operation

This heated underblanket must be fixed onto the mattress.
1. Leave space for the pillow and place the heated underblanket on the
mattress with the plug­in connector facing the pillow. Here, the plug­in
connector is located on the underside of the heated underblanket.
2. Stretch all of the elastic straps over the corners of the mattress. All 4
corners of the heated underblanket are then fixed onto the mattress.
CAUTION
Regularly check the position of the heated underblanket on the mattress.
The heated underblanket must never be used if it is folded.
After you have fixed the heated underblanket to the mattress, simply put your bed sheet on top as usual so
that the heated underblanket is between the mattress and the bed sheet.
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the control to the heated
underblanket by plugging in the connector.
• Then plug in the power plug into the mains outlet.

4.3 Switching on

To switch on the heated underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.

4.4 Setting the temperature

Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
NOTE:
• The fastest way to warm up the heatd underblanket is to initially set the highest temperature setting.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.
14