Replacing Batteries; Setting Normal Time; Year/Month/Date Setting; Time Setting - Eton ESP2000 Operación Manual

3

REPLACING BATTERIES

When the low battery symbol shows on the LCD display (20), open
the Battery door (19) at the bottom, replace the exhausted batteries
with three new alkaline "AA"batteries.
NOTE: If the AC/DC adapter is connected to the DC jack,the batt-
eries are used to maintain clock function only. The batteries can
operate the unit with full functions for only a few hours. The unit
should be operated with the included adapter.
4

SETTING NORMAL TIME

When power is on, the clock starts to enter the radio controlled
clock mode. The LCD display (20) initially shows:
- L: 0-5 receiving signal strength, 5 indicates signal level OK, 0-4
signal weak.
- 00-59: a count of seconds
- OFF: Alarm off mode
- The receiving tower symbol starts to blink. It indicates that the unit
has entered the time signal-receiving mode.
- If this unit is within the signal area: after receiving all signals
successfully, the clock shows the correct time and starts to work.
The blinking receiving tower symbol becomes steady. The time
signal is transmitted four times a day to auto-adjust the clock.
- If this unit is out of the signal area: Press MODE button (9) once,
the clock changes to normal clock mode. To set the correct time,
hold SET button (13) for two seconds to enter set mode.
6
E S P 2 0 0 0
5

YEAR/MONTH/DATE SETTING

- The LCD display (20) showing the year digits flashes, press UP
(10) or DOWN (12) button to set the year.
- Press MODE button (9) once to flash the month digits, then press
UP (10) or DOWN (12) button to set the month.
- Press MODE button (9) once again to flash the date digits, then
press UP (10) or DOWN (12) button to set the date.
- Press MODE button (9) once again to finish the setting or press
SET button (13) once to continue time setting.
6

TIME SETTING

- After entering set mode, press SET button (13) once to flash the
hour digits, then press UP (10) or DOWN (12) button to set the hour.
- Press MODE button (9) once to flash the minute digits, then press
UP (10) or DOWN (12) button to set the minute.
- Press MODE button (9) once again to finish the time setting or
press SET button (13) to continue alarm time setting.
O P E R A T I O N M A N U A L
7