Resol VBus/PWM Manual página 11

Target group
These instructions are exclusively addressed to authorised
skilled personnel.
Only qualified electricians should carry out electrical
works.
Initial installation must be effected by the system owner or
qualified personnel named by the system owner.
Instructions
Attention must be paid to the valid local standards, regula-
tions and directives!
Information about the product
Proper usage
The RESOL VBus /PWM interface adapter may only be
®
used for connecting an electronic controller for solar ther-
mal systems to a computer network or PC via the RESOL
VBus in compliance with the technical data specified in
®
these instructions. Improper use excludes all liability claims.
CE-Declaration of conformity
The product complies with the relevant directives
and is therefore labelled with the CE mark. The
Declaration of Conformity is available upon re-
quest, please contact the manufacturer.
Disposal
• Dispose of the packaging in an environmentally sound
manner.
• Dispose of old appliances in an environmentally sound
manner. Upon request we will take back your old appli-
ances bought from us and guarantee an environmentally
sound disposal of the devices.
Overview
Speed control of high-efficiency pumps for controllers
without integrated PWM outputs.
Easy to install.
Convertible from PWM to 0-10-V-Signal.
With 7-segment LED display.
The VBus /PWM interface adapter is used for the speed
®
control of a pump via a PWM or 0-10 V signal. Via the VBus
the adapter receives information from the controller about
speed. The speed is converted into a PWM or direct volt-
age signal and put out to the corresponding terminals.
A signal corresponding to the speed is only available if the
corresponding relay is designed for pump speed control.
Otherwise, a signal – depending on the position of the relay
– for the on or off state is transmitted.
®
11