Transcend mini cpap Guía Rápida página 9

STARTING AND ENDING THERAPY
Starting Therapy
1. The Transcend control
panel consists of a Power
button (bottom), Ramp
button (top), and two LED
lights. (Refer to image)
2. Ensure that the device is
connected to a power
source and is in Standby
mode.
3. Put on your mask and make sure that proper fit is achieved.
4. Press the lower, gray Power button (
flow will begin as the blower delivers your prescribed therapy pressure.
Using the Ramp Function
Ramp settings will be programmed by your healthcare provider as prescribed.
1. Initiate ramp by pressing the Ramp (top) button after the Power button has been pressed.
The Ramp button on the Transcend will not work unless your healthcare provider has preset
Note:
the ramp function.
2. Pressure from the device will be lowered to a preset starting pressure and will gradually increase
over a preset time interval until the device reaches your prescribed therapy pressure.
3. To accelerate the ramp time, hold down the Ramp button. The device will quickly increase
pressure until reaching your prescribed therapy pressure.
Ending Therapy
To end therapy, press the Power button to return the device to Standby mode.
Green LED
) to turn on Transcend and enter Therapy mode. Air
TRANSCEND QUICK GUIDE • ENGLISH
Ramp
Button
Power Button
• PAGE 9
Yellow LED