To Operate; Heat Settings - Homeright C900153 Manual Del Usuario

HOW TO USE THE LED HEAT GUN
• WARNING: To reduce the risk of injury, wear safety goggles or glasses with side shields.
• WARNING: Be aware that material behind or in between exposed surfaces may ignite.
• WARNING: To reduce the risk of burns and/or fire, keep the tool moving at all times over the material you are heating.
Low Fan Indicator Light
(–) Temperature Control Button
The Heat Gun comes with a two-stage switch allowing you to select a low or high fan speed. Each
fan speed has six temperature settings and can be controlled by pressing the temperature control
buttons (+ or –).

TO OPERATE

1. Plug the heat gun into a properly rated outlet.
2. If using an accessory nozzle tip, attach the desired tip first by sliding it onto the nose of the
heat gun.
3. To turn the heat gun on, slide the switch to Position I or II and use the + or – buttons to dial in
the desired temperature. It is suggested that you start in the lower heat range when beginning
an operation and then move to a higher temperature range if needed.
4. To turn the heat gun off after use, slide the switch to the bottom position, "O". The snowflake
icon will light blue showing that it is cooling down and the unit will automatically turn off in
80 seconds.

12 HEAT SETTINGS

The electronically controlled LED Heat Gun comes with 12 temperature settings, ranging
from Low (104°F) to High (1022°F). Refer to the Uses and Corresponding Heat Settings Chart
on Page 7 for your application needs.
Low Temperature
ENGLISH 6
How to Use
6 Temperature Indicator LED Lights
Cooling Down Indicator Light
Low Fan Speed
1 3 5 7 9
2 4 6 8 10
High Fan Speed
11
High Temperature
12
C900153 LED HEAT GUN
High Fan Indicator Light
(+) Temperature Control Button
TWO STAGE SWITCH
The Heat Gun comes with a
two-stage switch allowing
you to select a low or high
fan speed.