Kenmore 407.83086 Manual De Uso Y Cuidado página 16

On rare occasions, when the temperature or humidity is too high, the air conditioner may
not be able to evaporate all of the water as quickly as needed. All moisture that is unable
to be evaporated is placed in a water tank inside the unit. When the tank is completely full,
an alarm will sound, the compressor will shut off, and the bucket full icon will light up on
the control panel. To empty the tank, please follow the instructions below.
10mm (.4") Internal Diameter x 300rnm
(11.8") Drainage Hose
Clamp Drain Hose CtEp Drain Plug Screw
1) Remove the pre-installed Drain Cap from the unit (Fig 11).
B A
A. Drain Port
Fi,q. 11
B. Drain Cap
2) Attach the Clamp with the provided Screw (Fig. 12).
3)
\
\
\
A, Drain Port
B. Clamp
Fig. 12
Attach the Drain Hose to the Drain Port using the Drain Hose Clip. Insert the Drain Plug
into the free end of the Drain Hose and guide the Drain Hose through the Clamp. Once
finished, the unit can be easily drained by removing the drain plug and guiding the
drain hose into a small pan to drain the water (Fig. 13).
,!/
!
!
D
E
A. Drain Plug
B, Drain Port
C. Drain Hose
D. Drain Hose Clip
E, Clamp
Fiq. 13
A B C
16