Quick TSC Manual De Instalacion Y Uso página 8

CHARACTERISTICS AND INSTALLATION
GB
THRUSTER MAIN SWITCH COMMAND
By means of the TSC control, combined with the line switch TMS, the power supply of Quick
thrusters can be disconnected.
TSC can only work in a system where at least one TCD command and one TMS line switch are present.
Other important advantages of the TSC command are:
• Universal supply (from 8 to 31 Vdc).
• Can work in a wide range of ambient temperatures.
• Easy to install by means of connector system with optional extensions.
• Protection against reverse polarity.
INSTALLATION
BEFORE USING THE TSC, READ THIS INSTRUCTION MANUAL CAREFULLY.
IN CASE OF DOUBTS, CONTACT QUICK
F
In case of discordance or errors in translation between the translated version and the original text in the
Italian language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
The TSC is designed and constructed for the purposes described in this instruction manual. Quick
held responsible for any direct or indirect property damage or personal injury caused by inappropriate or unin-
tended use of the TSC, incorrect installation or any errors that may be present in this manual.
THE WARRANTY SHALL BE VOID IF THE TSC IS TAMPERED WITH OR ALTERED BY NON AUTHORISED
PERSONNEL.
THE PACKAGE CONTAINS: TSC - frame - drilling template - conditions of warranty - the present manual of
installation and use.
INSTALLATION OF THE TSC
The typical installation procedure is described herein, it is not possible to describe a procedure applicable for all
situations that may be encountered.
Adapt this procedure to satisfy your own personal requirements.
Locate the most suitable position to house the TSC following the recommendations given below:
• The TSC must be positioned so that it can easily be manoeuvred by the operator.
• Select a smooth and fl at area.
• Access from the rear must be available for installation and maintenance purposes.
• There must be enough space behind the chosen position in order to accommodate the rear of the TSC and
the wires.
• The rear part of the TSC must be protected from water and damp.
• Pay careful attention when drilling the panels or parts of the boat.
These holes should not weaken or break/crack the boat's structure.
8
® CUSTOMER SERVICE OR YOUR LOCAL DEALER
bow and stern
®
® .
shall not be
®
TSC MAIN SWITCH COMMAND - REV001B