AKO 5012 Guía Rápida página 11

Search for installed devices
The access data are requested. By default, these are:
User: superuser
Password: superuser
If the application does not have registered devices, the device search window appears. Press the "Search for
devices" button to start the search.
The "Start" and "End" parameters define the MODBUS range of addresses where devices are searched for. To
reduce the search time, it is advisable to adjust these parameters according to the configuration of your
installation.
After a few moments, the application displays a list of devices found.
To save each device, press the "Save" button. This opens a new window where the data for each device are
defined:
To facilitate subsequent location, it is advisable to assign a different name to each device, enter the name chosen
in the "Name" field and press "OK".
If after 5 minutes the application cannot find any device, check the configuration of the AKO-80039
converter (see the following page) and the range of addresses defined.
If you use an AKO-80080 converter, see the following page.
The application is ready to operate. View the AKONet user manual by pressing the ? icon at the top right
hand side of the application.
11
5012H001 Ed.01