How Does Marmitek X-10 Work; Signal Range - Marmitek Easy Icon 10 RF Modo De Empleo

HOW DOES MARMITEK X-10 WORK?

Marmitek X-10 components use the existing mains wiring to communicate (using
Marmitek X-10 signals). You can build a complete system using the three different kind
of components of the Marmitek X-10 System:
1. Modules:
2. Controllers:
3. Transmitters: Wireless components like remotes. The signals of these components
ADRESSES
Up to a maximum of 256 different addresses can be preset. These are subdivided into a
so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can
also be set on the controllers, so that the controllers and modules become part of the
same system. The address can be set either using code dials or by pressing buttons,
depending on the type of module.
The Marmitek X-10 System uses standard commands, which control all units with the
same HouseCode at the same time (e.g. all lights on, all off, etc.).

SIGNAL RANGE

Range of Marmitek X-10 signals over the Power Line and how to increase the
range.
The Marmitek X-10 System is based on power line communication. The range of the
Marmitek X-10 signals very much depends on the local circumstances. On average the
range is a cable length of 80 meters.
If you have difficulties with the range of your Marmitek X-10 signals, please
pay attention to the following facts:
1. When more than one phase is used for your electrical system, it is necessary to cou-
ple these phases for the Marmitek X-10 signals. For coupling you can use FD10 Phase
Couplers/Filters. You only need to install a Phase Coupler/Filter when your wall outlets
and light switches are divided over more than one phase (more than one group is no
problem). For bigger buildings or longer distances we advice you to use an active
repeater instead of passive FD10's.
2. It is possible that Marmitek X-10 signals are attenuated by devices and lights which
4
These components will receive Marmitek X-10 signals and will switch
or dim the attached lamp or appliance. Examples of these modules
are lamp modules and appliance modules. These are available as
build-in, micro, DIN rail and plug-in modules.
These components will transmit Marmitek X-10 signals and thus will
control the Modules.
will be received by a controller with transceiver functionality (IRRF
7243, TM13 or CM15Pro). The Transceiver will translate the signals
into Marmitek X-10 signals on the power line.
© MARMITEK