General Introduction; Turn On The Power Switch - Reolink Argus PT Guia De Inicio Rapido

General Introduction

Speaker
Status LED
Lens
Built-in PIR Sensor
Daylight Sensor
Built-in Mic
Reset Hole
Micro SD Card Slot
Battery Status LED
Micro USB Port
Antenna
Power Switch
The LED in Red (Wi-Fi connection failed) The LED in Blue (Wi-Fi connection succeeded)
Blinking: Standby status Blinking: Standby status
On: Working status On: Working status
2 English
Install the Antenna

Turn on the Power Switch

The power switch of Reolink Argus PT is off by default. Please turn it on before setting up the camera.
Please install the antenna to the camera.
Rotate the antenna base in a clockwize
motion. Leave the antenna in a vertical
position for the best reception.
Note:
If you don't use the camera
for a long time, please turn
off the power switch.
English 3