Elements And Controls; Setup; Microphone Holder; Antenna - Team Electronic VX-2412 Manual De Instrucciones

English

ELEMENTS AND CONTROLS

1 Mode / Keylock
2 Squelch SQ / ASQ
3 Microphone Connector
4 Channel UP Key
5 Channel DOWN Key
PIN 1 Modulation
PIN 2 Speaker
PIN 3 PTT
PIN 4 Up/Down
PIN 5 Ground
PIN 6 +12 Volt
18
TEAM VX-2412
Front
Rear
6 Priority Channel / Menu
7 Volume Control & On/Off
8 Connector external Speaker
9 Antenna Connector
VX-2412
Base the decision about the position of the VX-2412 radio and the microphone
in your vehicle on the aspect of safety and convenience. No part of the setup,
i.e. radio, microphone, cable, etc., should restrict or obstruct the driver or pas-
senger in any way at any time.
U-Bracket Holder
Mount the U-shaped bracket holder with the screws and the washers at the
best location in the vehicle.

Microphone Holder

Base the decision about the position of the microphone holder in your vehicle
on the aspects of safety and convenience. No part of the setup, i.e. radio,
microphone, cable, etc., should restrict or obstruct the driver or passenger in
any way at any time.
Mount the microphone holder with the two threading screws onto the desired
location in the vehicle.

Antenna

The antenna should be matched with the radio, otherwise a part of the trans-
mit power will be reflected in the antenna and will not be radiated. This will
reduce the range of operation.
Since the antenna is one of the most important links in the setup, the following
criterias are very important.
LCD

SETUP

English
19