Work Sharp WS2000 Guia Del Usuario página 12

12
STEP 3
Place tool in sharpening port under the
tool hold-down, on the right side of align-
ment fence.
STEP 4
Slide fence against left edge of tool in port
and hand tighten alignment fence knob.
STEP 5
Keeping the tool flat on the sharpening
port diamond surface; "plunge and pull"
the tool in and out of the sharpening port
to sharpen the bevel.
Plunge
www.worksharptools.com
Only contact the wheel during "plunge" for
one-half to one second.
Repeat "plunge and pull" sharpening in
the sharpening port until a consistent
finish, or desired sharpness is achieved.
For best surface finish and sharpness, flip
wheel so fine abrasive is face down and
repeat step 5.
Edge-Vision
Underside Port—
For small carving tools,
screwdrivers, and general
grinding
Tip
Use a permanent marker to color
the edge of your tool to be sharp-
ened.
Step 1
Mount the Edge-Vision
and turn unit around so you are facing the
underside port on backside of tool.
Step 2
Slowly bring tool into the Edge-Vision
underside port under the wheel.
Pull
TM
TM
Edge-Vision Port
TM slotted wheel
TM