Profile 100000301 Manual Del Usuario página 15

Portable Gas Heater
100000301 Atria
Caution: It is important that you read this manual before using the product Then
keep this manual in a safe place. Only use this product in a well ventilated space.
Warning: To ensure the safe operation of your heater the appliance must be
assembled and connected according to the instructions in the manual. Ignoring
these instructions can cause a fire or explosion that can damage the appliance and
cause serious injuries. Then the supplier/manufacturer can no longer be held
responsible.
Technical information
Model
EU standard
Appliance category
Gas type
Gas pressure (mbar)
Destination countries
Load KW (g/h) (Hs)
3 positions
Ignition
Connecting the gas bottle
 Place the gas bottle in the opening in the back of the appliance.
 Fasten the gas bottle in the protection element so that it is no longer able to move.
 Connect the hose (not supplied) to the appliance and connect the other end to the pressure regulator (not
supplied). Then connect the pressure regulator to the gas bottle (screw tight anticlockwise)
 Check all connections by rubbing them with a water/soap mixture. Open the pressure regulator and slowly open the
gas valve on the gas bottle. The connections have been correctly made if no bubbles are seen. Should there
appear to be a leak, close the gas valve and do not use the appliance again until it has been checked by a qualified
installer.
 Always use a certified gas pressure regulator (EN12864) that suffices with regard to local regulations.
 Always use a hose that suffices with regard to the applicable standards. The hose must be replaced by an
equivalent hose before the expiry date mentioned on the hose.
Replacing the gas bottle
 Close the pressure regulator and the gas valve and make sure the appliance has fully cooled before replacing the
gas bottle. Never replace the gas bottle when the appliance is working!
 Do not replace the gas bottle in a space with naked flames.
 Do not smoke while replacing a gas bottle.
 Connect the hose and pressure regulator again according to the instructions in 'Connecting the gas bottle'
PCL-387
EN449
I3+
G30 (butane), G31 (propane)
G30: 28-30mbar/G31: 37mbar
BE
4.1KW (299g/h)
1400W/2750W/4100W
Piezo ignition
EN - 1