Publicidad
Idiomas disponibles
Idiomas disponibles
Grow-Flex
Feed System
TM
5. Bolt the Unloader to the Transfer Plate using four 5/16"-18 x 1" Slotted Screws, washers, and
Nuts. Please note proper inlet/outlet orientation of Lower Boot prior to assembly. This
procedure is the same for all Unloader Configurations.
6. Connect Auger Tube(s), Auger and Anchor Bearing(s) to unloader. Tube and Auger
installation should be in accordance with the manufacturers (OEM) installation guidelines. Be
sure to follow auger manufacturers' auger stretching recommendation during Anchor Bearing
assembly. As a general rule: Stretch the auger 2 inches for every 50 feet of auger length.
7. Once installation is complete; Access/Clean-out Plate can be assembled.
1. Loosen wing nuts to end of studs.
2. Start lower side of access plate in unloader boot opening (Figure 3).
3. Slide access plate up as far as possible so plate catches top of unloader boot
4. Hold access plate in place while tightening wing nuts (Figure 4).
Hog Slat Inc. Newton Grove, NC USA November 2015
Unloader Boot and Restrictor Baffle Guide
opening.
Figure 3
Figure 2
Figure 4
4
Publicidad
