Seac T5 Instrucciones página 15

PRE-DIVE INSPECTION
• If your torch has not been used recently, check the condition of the batteries
by ensuring that it switches on.
• Check that the body is fully closed.
• As soon as you enter the water, check that no bubbles emerge from the
body of the torch.
RECHARGING THE BATTERY (if using the Li-ion 18650 3.7
V – 2200 mAh rechargeable battery, optional)
These instructions are valid ONLY if you have purchased the optional
rechargeable battery and corresponding SEAC battery charger.
Under no circumstances should you attempt to recharge an alkaline
battery, as this could cause a risk of explosion and/or fire.
• Unscrew the end cap counter-clockwise (where the strap attaches).
• Pull the battery out of the torch body.
Pay the utmost attention to ensuring that there are no flammable objects
or products near the torch while it is charging.
• Insert the battery in its seat in the battery charger, taking care to match the
polarity direction shown on the battery charger and the battery itself. They
must always match.
• Insert the micro-USB cable connector to the port on the charger and
connect the other end to a 5 Volt, 1-2 Amp power adapter. A red LED will
turn on immediately on the top of the battery charger, on the micro-USB
port side. This indicates that the battery is charging. When the battery is fully
797 - Manuale Seac torce serie T5 - TOTALE.indb 15
Safety engaged
Safety disengaged

WARNING

WARNING
T5
15
12/09/2018 14:36:52