Safety And Warranty - Rega P8 Manual Del Usaurio

Safety and warranty

• Do not use this unit near liquids, or expose to moisture.
• Do not use near sources of heat such as radiators, vents, stoves, or candles.
• Ensure adequate ventilation around the product, at least 10 cm in all directions, and avoid placing the unit on soft surfaces
such as long carpet and fabric.
• Do not open the product enclosure or force objects into openings in the unit.
• Place the unit on a fixed level surface where it will not fall or tip.
• The unit should only be used in moderate climates between 5 °C (41 °F) and 35 °C (95 °F).
• Keep packaging material and small pieces out of reach of children.
• Unplug the power supply if the unit is unused for extended periods of time.
With the unit disconnected from the mains, only clean with a microfibre cloth (lightly damp if necessary). If the unit performs
erratically or emits smoke or odour, disconnect from the power supply and take it to a qualified service technician.
• All Rega products are covered by a lifetime warranty against manufacture defects.
• This warranty does not cover wear and tear.
• Any unauthorised modifications or failure to follow the Rega recommended guidelines may invalidate the warranty.
• If returning goods for inspection to your retailer, the original packaging must be used to preserve warranty.
• Replacement packaging is available from any Rega retailer.
• Your statutory rights are not affected.
Neo specifications
Output to motor bi-phase = 24 V AC protected by resettable fuse.
Power consumption = 7.2 W
Voltage = 24 V AC. Rega PSU1 only.
Speed control step size = 0.01 RPM
Stroboscopic disc = 100 Hz, 180 marks 331/3 RPM
The basic one bar per minute drift resolution = 0.016%
PS1 (UK) PS1 (Australian)
Input 230 V ~ 50 Hz 0.07 A Input 230 V ~ 50 Hz 0.07 A
Output 24 V ~ 350 mA AC Output 24 V ~ 350 mA AC
PS1 (EU - Euro 2 pin) PS1 (Japan)
Input 230 V ~ 50 Hz 0.07 A Input 100 V ~ 50/60 Hz
Output 24 V ~ 350 mA AC Output 24 V ~ 350 mA AC
PS1 (UL - American) PS1 (Korea)
Input 115-120 V ~ 60 Hz Input 220 V ~ 60 Hz 0.07 A
Output 24 V ~ 350 mA AC Output 24 V ~ 350 mA AC
Warnings
• Do not unplug the power supply from the turntable whilst the unit is on - turn off the power supply before unplugging.
• Do not operate the power supply without the turntable connected.
• A 24 V AC plus a 20 V DC signal present on the pins of the plug - if these are shorted it will cause damage to the power unit.
• Use only with the Rega PS1 power supply or Neo.
• Do not open the case covers. There are no user serviceable parts inside.
The Neo incorporates resettable fuses in the driver amplifier to protect it from overcurrent faults, which will cause the turntable to
run erratically or not at all. If in the rare circumstance these are activated, they are reset by turning off the Neo via the front panel
for approximately 10 seconds. If the fault should persist, consult your dealer.
4