Specification; Dimensions And Connections - Stiebel Eltron DHC Serie Operación E Instalación

Minicalentador de control hidráulico
Ocultar thumbs Ver también para DHC Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
INSTALLATION

Specification

Adjusting the flow rate
If the required temperature is not achieved, you can limit the flow
rate. This will give you a higher temperature.
f Set the flow rate with the adjusting screw in such a way that
f
the outlet temperature complies with the details in chapter
"Specification / Data table".
Clean sieve
You can clean the fitted sieve after removing the cold water con-
nection pipe.
1.
90°
2.
1 Earth screw
2 Strainer
3 Cold water connection pipe
f Undo the earth screw by approx. two turns.
f
f Loosen the cold water connection pipe by turning the pipe
f
in the differential pressure switch through 90° and pulling it
down.
f Clean the strainer and replace if required.
f
f Reinstall the parts in reverse order.
f
Material damage
!
Always secure the earth screw.
24
| DHC
Activating the high limit safety cut-out
Once faults have been remedied, you can reactivate the high limit
safety cut-out.
f Isolate the appliance from the power supply and depressur-
f
ise the water line. Push in the high limit safety cut-out reset
button.
Appliance storage
f Store the dismantled appliance in a room free from the risk
f
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
15. Specification

15.1 Dimensions and connections

1
DHC 3, DHC 4, DHC 6, DHC 8
2
3
c06
c06
b02 Entry electrical cables 1
c01
Cold water inlet
c06
DHW outlet
b02
54
c01
c01
35
100
200
Male thread
Male thread
www.stiebel-eltron.com
104
G 1/2 A
G 1/2 A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dhc 3Dhc 4Dhc 6Dhc 8Dhc 6 u

Tabla de contenido