Escalade Sports Atomic g04864w Guia De Inicio Rapido página 7

8 pcs - H6 Hex Bolt
8 pcs - H4 Flat Washer
STEP 4:
Attach P5 Side Leg Panels between P2 Right Legs and P3 Left Legs using H6 Hex Bolts with H4 Flat Washers as
shown in FIGURE 4. Use T1 Wrench to tighten all bolts. Remember to tighten all H1 Leg Bolts from STEP 1.
STEP 5:
Attach P8 Leg Panel Support Blocks to bottom of Leg assembly using pre-drilled pilot hole with H7 Screws as
shown in FIGURE 5. Tighten, but do not strip out H7 screws.
Thread P9 Leg Levelers into the Leg assembly as shown in FIGURE 5.
P9
H7
P8
THIS STEP REQUIRES FOUR OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL. THE TABLE IS VERY HEAVY.
All Rights Reserved.
© 2012 Escalade Sports
4 pcs - H7 Screw
2 pcs - P5 Side Leg Panel
P2
P3
H6
H4
P5
H7
P8
PARTS REQUIRED:
4 pcs - P8 Leg Panel Support Block
4 pcs - P9 Leg Leveler
NOTE: Small wooden tab on end of
P5 Side Panel must face the leg.
P3
P2
P5
H6 H4
P9
P9
7
1 pc - T1 Wrench
FIGURE 4
NOTE: Small wooden tab
on end of P5 Side Panel
must face the leg.
FIGURE 5
P9
H7
P8
P8
For Customer Service Call 1-888-996-2729
H7