RIB S1 Manual Del Usuario página 27

ACCESSORIES -
RADIO TRANSMITTER SUN
SUN 2CH cod. ACG6052
SUN CLONE 2CH cod. ACG6056
CODE LEARNIG SYSTEM RADIORECEIVERS
S433 1CH 1-channel with connnector
S433 1CH 1-channel with terminal Block
S433 2CH 2-channels with connnector
S433 2CH 2-channels with terminal Block
S433 4CH 4-channels with connnector
S433 4CH 4-channels with terminal Block
SPARK
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention to not let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD
LATERAL SUPPORT
SPARK ANTENNA 433
For the connections and the technical data of the optional equipments follow the relevant handbooks.
SUN 4CH cod. ACG6054
SUN CLONE 4CH cod. ACG6058
code ACG5081
code ACG5082
code ACG5083
code ACG5084
code ACG5085
code ACG5086
code ACG7059
code ACG7042
code ACG5452
FIT SYNCRO
FIT SYNCRO PHOTOCELLS for the wall-installation
The range you can set is 10-20 m, 30÷60ft.
You can fit many couples close together thanks to the synchronising circuit.
Add the SYNCRO TRANSMITTER
for more than 2 photocells couples (up to 4).
COUPLE OF BUILT-IN BOXES FOR THE FIT SYNCRO
PAIR OF COLUMNS FOR FIT SYNCRO
BLOCK
BLOCK KEY SELECTOR FOR WALL-INSTALLATION
BLOCK KEY SELECTOR TO BUILA-IN
PROBE
The probe detects the motor temperature to operate the heating system under low
temperature conditions, up to -30°C (connect to connector J6).
27
code ACG8026
code ACG8028
code ACG8051
H = 0,5 m code ACG8057
code ACG1053
code ACG1048
code ACG4665
G
B