Operating Conditions - Forest-Master FM5 Manual De Instrucciones

OPERATING CONDITIONS

This log splitter is a home use model. It is designed for operating under
ambient temperatures between +5°C and 40°C and for installation at
altitudes no more than 1000m above M.S.L. The surrounding humidity
should be less than 50% at 40°C. It can be stored or transported under
ambient temperatures between -25°C and 55°C.
ELECTRICAL REQUIREMENTS (FM5, FM8, FM10)
Connect the main leads to a standard 230V±10% (50Hz±1Hz) electrical
supply which has protection devices of under-voltage, over-voltage
and over-current as well as a residual current device (RCD) which is
maximum residual current rated at 0.03A.
This equipment is fitted with a UK 3 pin mains electricity plug and
is supplied with a 2 pin adapter for use where necessary. DO NOT
remove the 3 pin mains electricity plug and fit a 2 pin mains electricity
plug.
Before using the splitter, attach the two rubber feet supplied, to the
plate on the bottom of the front foot, using the nuts and washers
supplied.
POSITIONING THE LOG
This end slightly raised
SPLITTER
The log splitter should be
positioned level or preferably
positioned with the end where
the fixed wedge is, slightly
raised. A difference of 5mm
over the length of the log
splitter is sufficient.
It should not be positioned with the fixed wedge end lower than the
operating handle end as this may limit the flow of oil to the pump.
10 FM5, FM8 & FM10 (All Versions)