Air-Tightness Test - Mitsubishi Electric CITY MULTI PURY-P-TNU-A Serie Manual De Instalación

9-5-3. Sealing the openings around the pipes
Seal all openings around pipes and wires to keep out small animals, rainwater, or snow.
- Failure to do so may result in current leakage, electric shock, or damage to the unit.
Ⓐ

9-6. Air-tightness test

Do not use oxygen, flammable gas, or a refrigerant containing chlorine for air-tightness testing.
- Doing so may result in an explosion. Chlorine will deteriorate the refrigerant oil.
After refrigerant pipe installation is completed, check the system for leaks by conducting an air-tightness test. If there is a leak, the composition of
the refrigerant will change and the performance will drop.
<Air-tightness test procedures>
① Make sure the service valves are closed.
② Add pressure to the refrigerant pipes through the service ports of the high- and low-pressure pipes.
* Pressurize to the design pressure (4.15 MPa) using nitrogen gas.
③ If the pressure holds for one day and does not decrease, the pipes have passed the test and there are no leaks. If the pressure decreases,
there is a leak. Look for the source of the leak by spraying a bubbling agent (e.g., Gupoflex) on the flared or brazed sections.
④ Wipe off the bubbling agent.
Ⓐ
Ⓓ
WT09106X03
Ⓑ
Ⓕ
Ⓑ
Ⓑ
Ⓒ
HI
LO
Ⓔ
Example of closure materials (not supplied)
Ⓐ
Ⓑ Fill the openings
Ⓐ Nitrogen gas
To indoor unit
Ⓑ
Ⓖ
Gauge manifold
Ⓒ
Ⓓ Low pressure knob
Ⓗ
Ⓔ High pressure knob
Ⓕ Service valve
Ⓘ
Low-pressure pipe
Ⓖ
Ⓙ
High-pressure pipe
Ⓗ
Ⓘ Outdoor unit
Ⓙ Service port
GB-24