Setting The Speed; Setting The Level "Soft-Start" And "Soft-Stop; Setting The Level Of Sensitivity To Obstacle / Drc; Climatic Sensors - Nice TTPRO BD Instrucciones Y Advertencias Para La Instalación Y El Uso

3.6.3 - SETTING THE SPEED

Press the button : the current setting will appear on the level LEDs.
01.
If a speed value has been set with procedure 3.6.2, the LEDs flash to indicate
the approximate closest value.
Use the button or , until to turn on the LED that corresponds to the
02.
desired setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected and its
maximum and minimum
2
speed values.
3
4
5
6
7
8

3.6.4 - SETTING THE LEVEL "SOFT-START" AND "SOFT-STOP"

Press the button : the current setting will appear on the level LEDs.
01.
RDC
Use the or button to turn on the LED that corresponds to the desired
02.
setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected.
2
3
4
5
6
7
8
RDC
Speed (RPM)
6
12
20
26
32
40
48
56
Rpm acceleration/deceleration
0.0
0.7
1.5
2.0
2.5
3.0
3.5
4.0

3.6.5 - SETTING THE LEVEL OF SENSITIVITY TO OBSTACLE / DRC

Press the button : the current setting will appear on the level LEDs.
01.
RDC
Use the or button to turn on the LED that corresponds to the desired
02.
setting.
03. ➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected.
2
3
4
5
6
7
8

3.7 - Climatic sensors

3.7.1 - SETTING THE INTERVENTION LEVEL FOR "WIND" PROTECTION

Press the button : the current setting will appear on the level LEDs.
ON
01.
If no "wind" protection, has been set, the level LEDs flash simultaneously.
Use the or button to turn on the LED that corresponds to the desired
02.
setting.
03. ➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: The number of levels available depends on the type of motor connected and the
maximum and minimum values of this motor.

3.7.2 - ENABLING/DISABLING OF CLIMATIC SENSORS

This button allows you to enable/disable the intervention of the SUN and RAIN sensors.
If the function is active, the corresponding LED will be lit, otherwise off.
Press the button to activate/deactivate the SUN and RAIN sensors: the cor-
ON
01.
responding LED starts flashing.
02.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Level
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
LEVEL 5
LEVEL 6
LEVEL 7
LEVEL 8
English – 8